Installation Guide: IntelliFlo3 and IntelliPro3 vsf pool Pump

Refer to the tables below for factory default settings:
PROGRAMS
Program 1 
Schedule Mode; 30 GPM
12 AM to 12 AM (24 Hour)
Quick Clean
Timer Mode; 70% Speed
1 Hour
PRIMING PARAMETERS
Priming Mode
Enabled
Dry Run Detection
Enabled
Priming Speed
100%
Max Priming 
Duration
11 Minutes
Priming Range
5
Delay
20 Seconds
Loss of Prime 
Detection
Enabled
LIMITS PARAMETERS
Min Speed
1%
Max Speed
100%
Min Flow
20 GPM
Max Flow
90 GPM
(1.5 HP Pumps)
140 GPM
(3 HP Pumps)
Flow Limit - 
Speed Programs
Disabled
Max Pressure
20 PSI
(1.5 HP Pumps)
30 PSI
(3 HP Pumps)
Pressure Limit - 
Speed Programs
Disabled
THERMAL MODE
Thermal Mode
Enabled
Temp Set Point
40°F
Pump Setting
20% Speed
AUTOMATION ADDRESS
Pump Address
1
EXTERNAL CONTROL PROGRAMS
Program 1
40% Speed
Program 2
60% Speed
Program 3
80% Speed
Program 4
100% Speed
RAMPING SPEED
Speed
Fast
DEVICE SECURITY
Security PIN
Disabled
OTHER
Language
English
Time Zone
UTC -5:00
Daylight Savings Time
Enabled
Units
°F / GPM / PSI

---

8
INTELLIFLO3™ VSF / INTELLIPRO3™ VSF Variable Speed and Flow Pump Installation and Maintenance Guide
Pentair Home App Operation
Your IntelliFlo3 VSF or IntelliPro3 VSF pump is fully compatible with the Pentair Home app.
The Pentair Home app allows you to program and operate the pump from your smartphone. For instructions on how to 
create an app account and operate your pump via the Pentair Home app, refer to the 
Pentair Home User's Guide (P/N 
356088)
provided with your pump. 
Touchscreen Operation 
(if installed)
If you prefer to control your pump directly from the equipment pad, a touchscreen controller allows you to adjust pump 
settings and program run schedules via a touchscreen mounted directly onto the pump drive. The following sections 
provide instructions for using your touchscreen controller. 
Some pump models do not include a touchscreen controller out-of-box, but a touchscreen can be added to any 
IntelliFlo3 VSF or IntelliPro3 VSF pump. If you would like to add a touchscreen to your pump, Pentair offers a 
Touchscreen Controller Kit (Almond - P/N 356159z, Black - P/N 356348z).
Pump Dashboard
The Pump Dashboard is your pump's home screen. Basic pump info, run status and programming can be viewed from 
this screen.
Pump alerts or other problems will also display on this screen.
1− Active Alerts:
Displays any active pump alerts and/or warnings.
2− See Running Programs:
View and edit your pump's current programs. Refer to 
Program Setup, page 9
.
3− Current Run Data: 
Displays the current pump state and program run data when the pump is running.
4− Relay Device Status: 
Displays the status (ON/
OFF) of devices connected to the pump's 5A 
and/or 16A relay terminals. 
Note:
Relay statuses will only display if the 
optional Relay Control Board (P/N 356365z) is 
installed.