Head 1 (units)a
|
Head 2
|
Head 3
|
Head 4 (units)
|
Column 1
|
Column 2
|
Column 3b
|
Column 4
|
Column 1
|
Column 2
|
Column 3
|
Column 4
|
Column 1
|
Column 2
|
Column 3
|
Column 4
|
a Table Footnote;
b Table Footnote.
|
|
|
|
Tables. All figures and schemes should be cited in the main text in consecutive numerical order, i.e. Table 1, Table 2, Tables 3–5, etc.
Equations. It is preferable to use a word equation editor or MathType for equations. All equations should be cited in the main text in consecutive numerical order with no abbreviation, i.e. Equation 1, Equations 1 and 2, etc. Please punctuate equations as regular text. This is an example of an equation:
Limitations
This is a mandatory part for all papers accepted for publication in 2023. The authors are required to provide in this section any difficulties and limitations appeared during their research and to propose possible solutions for overcoming the remaining issues in the future. For Focus Reviews and Reviews, uncovered gaps or little discussed problems can be mentioned. Therefore, this section acts as a starting point for carrying out further activities in the corresponding research direction.
Conclusions
This section is mandatory and must have a first-order heading. Between the Conclusion and Reference sections, the following Disclaimers should be properly filled: Supplementary materials, Funding, Acknowledgments, Author contributions, Conflict of interest, and Additional information.
Please do not remove any of these disclaimers!
● Supplementary materials
Please use this option in case of a higher number of illustrative materials than specified on the Section Policies page. In this case, please use the following phrase: ‘This manuscript contains supplementary materials, which are available on the corresponding online page’.
You are welcome to present brief contents of each component in the Supplementary Materials file, see the following examples.
Figure S1: The XRD data of the powders obtained;
Figure S2: High-resolution SEM analysis for the A powder;
Table S1: Lattice parameters for the single-phase materials.
Note that all these components should be properly cited in the main text of the manuscript.
The Chimica Techno Acta journal does not accept Appendix section(s), please use the Supplementary materials option instead.
In case of absence of any additional materials, please state ‘No supplementary materials are available’.