Cisco Certified Network Associate 0 (ccna)

Correct Answer: A


QUESTION 14
Refer to the exhibit.

The network engineer is configuring a new WLAN and is told to use a setup password for authentication instead of the RADIUS servers. Which additional set of tasks must the engineer perform to complete the configuration

1. 
   Disable PMF Enable PSK Enable 802.1x
   
2. 
   Select WPA Policy Select WPA2 Policy Enable FT PSK
   
3. 
   Select WPA2 Policy Disable PMF Enable PSK
   
4. 
   Select WPA Policy Enable CCKM Enable PSK
   

Correct Answer: C


QUESTION 15
Refer to the exhibit.

SW1#show run Building configuration...

!
hostname SW1
!
ip domain-name test
!
username CCNA privilege 1 password 0 ciscol23
!
interface FastEthernet01 switchport access vlan 10
!
interface Vlan10
ip address 192.168.1.2 255.255.255.0
!
line vty 0 4 login local
transport input telnet line vty 5 15
login local
transport input telnet

SW1#show crypto key mypubkey rsa

% Key pair was generated at 0123 UTC Mar 1 2021 Key name SW1.test

An engineer is updating the management access configuration of switch SW1 to allow secured, encrypted remote configuration. Which two commands or command sequences must the engineer apply to the switch (Choose two)

1. 
   SW1(config)#line vty 0 15 SW1(config-line)#transport input ssh
   
2. 
   SW1(config)# crypto key generate rsa
   
3. 
   SW1(config)# interface f01 SW1(config-if)# switch port mode trunk
   
4. 
   SW1(config)#enable secret ccnaTest123
   
5. 
   SW1(config)# username NEW secret R3mote123
   

Correct Answer: AE