Cisco Certified Network Associate 0 (ccna)

Correct Answer: A


QUESTION 40
Which is a fact related to FTP?

1. 
   It uses block numbers to identify and mitigate data-transfer errors
   
2. 
   It always operates without user authentication
   
3. 
   It relies on the well-known UDP port 69.
   
4. 
   It uses two separate connections for control and data traffic
   

Correct Answer: D


QUESTION 41
Which two protocols are used by an administrator for authentication and configuration on access points? (Choose two)

A. Kerberos

B. 802.1Q
C. 802.1x
D. TACACS+
E. RADIUS
Correct Answer: CE


QUESTION 42
Refer to the exhibit.
CPE1# show protocols e0/1 Ethernet0/1 is up, line protocol is up Internet address is 10.0.12.2/24

CPE1#show ip access-list LAN Standard IF access list LAN

10 permit 10.0.12.0, wildcard bits 0.0.0.255 CPE1# show ip nat translations
CPE1# show ip net statistics

Total active translations: 0 (0 static, 0 dynamic, 0 extended)

Peak translations: 0 Outside interfaces:
Inside interfaces:
Ethernet0/1 Hits: 0 Misses: 0
CEF Translated packets: 0, CEF Funted packets: 0 Expired translations: 0
Dynamic mappings:
-- Inside Source
[Id: 1] access-list LAN pool NATPOOL refcount 0 pool NATPOOL: netmask 255.255.255.0
start 198.51.100.11 end 198.51.100.20
type generic, total addresses 10, allocated 0 (0%), misses 0

Total doors: 0

Appl doors: 0
Normal doors: 0
Queued Packets: 0

What is the next step to complete the implementation for the partial NAT configuration shown?

1. 
   Reconfigure the static NAT entries that overlap the NAT pool
   
2. 
   Configure the NAT outside interface
   
3. 
   Modify the access list for the internal network on e0/1
   
4. 
   Apply the ACL to the pool configuration