Cisco Certified Network Associate 0 (ccna)

Correct Answer: D


QUESTION 28
Refer to the exhibit.

SW1#show ip interface brief

Interface IP-Address OK? Method Status Protocol FastEthernet0/1 unassigned YES manual down down

SW1#show interface fa0/1 status

Port Name Status Vlan Duplex Speed Type Fa0/1 notconnect 1 a-full a-100 10/100BaseTX

What is the cause of the issue?

1. 
   STP
   
2. 
   shutdown command
   
3. 
   port security
   
4. 
   wrong cable type
   

Correct Answer: D


QUESTION 29
Refer to the exhibit.

Router1#show ip route

Gateway of last resort is 10.10.11.2 to network 0.0.0.0
209.165.200.0/27 is subnetted, 1 subnets
B 209.165.200.224 [20/0] via 10.10.12.2,03:32:14
209.165.201.0/27 is subnetted, 1 subnets
B 209.165.201.0 [20/0] via 10.10.12.2,02:26:53
209.165.202.0/27 is subnetted, 1 subnets
B 209.165.202.128 [20/0] via 10.10.12.2,02:46:03
10.0.0.0/8 is variably subnetted, 10 subnets, 4 masks
C 10.10.10.0/28 is directly connected, GigabitEthernet0/0 C 10.10.11.0/30 is directly connected, FastEthernet2/0
C 10.10.12.0/30 is directly connected, GigabitEthernet0/1
O 10.10.13.0/25 [110/2] via 10.10.10.1, 00:00:04, GigabitEthernet0/0
O 10.10.13.128/28 [110/2] via 10.10.10.1, 00:00:12, GigabitEthernet0/0 O 10.10.13.144/28 [110/2] via 10.10.10.1, 00:01:57, GigabitEthernet0/0 O 10.10.13.160/29 [110/2] via 10.10.10.1, 00:00:12, GigabitEthernet0/0 O 10.10.13.208/29 [110/2] via 10.10.10.1, 00:01:57, GigabitEthernet0/0 O 10.10.13.252/30 [110/2] via 10.10.10.1, 00:01:57, GigabitEthernet0/0 S* 0.0.0.0/0 [1/0] via 10.10.11.2

Drag and drop the subnet masks from the left onto the corresponding subnets on the right. Not all subnet masks are used.

A. 10.10.13.0 – 255.255.255.128

10.10.13.128 – 255.255.255.240
10.10.13.160 – 255.255.255.248
10.10.13.252 – 255.255.255.252