Read MI Table Links == <.mif/.mid_file> 50
Read Materials File == 51
Relative Resistance == [ {RELATIVE} | MATERIAL ] 51
S Channel Approach == [ PRE 2004-06-AA ] 51
Storage Above Structure Obvert == [ {CHANNEL WIDTH} | ] 51
Trim XZ Profiles == [ ON | {OFF} ] 52
XS Database == 52
[ BG | CS | NA | VG ].... ! Fixed Field Flags 60
BG Data == 60
CS Data == 60
NA Data == 61
VG Data == 61
Read MI IWL == <.mif/.mid_file> 69
Set IWL == 69
BC Database == <.csv_file> 77
BC Event Name == 77
BC Event Text == 78
EB Data == 78
Read MI BC == <.mif/.mid_file> 78
Cell Size == 9
Grid Size (N,M) == , 9
Grid Size (X,Y) == , 9
Orientation == , 9
Orientation Angle == 10
Origin == , 10
Read MI Location == <.mif/.mid_file> 10
Read TGA == <.tga_file> 18
Read TGF == <.tgf_file> 18
External Bndy == , , , 27
Read MI [ MAT | IWL | CnM | FRIC | WrF | FLC ] == 28
Read MI Code [ {} | BC ] == 28
Read MID [ CODE | MAT | IWL | CnM | FRIC | WrF | FLC ] == 28
Read MID Grid == 29
Set [ CODE | MAT | IWL | CnM | FRIC | WrF ] == 29
Write MI Domain == <.mif/.mid_file> 29
Write MI Grid == <.mif/.mid_file> 29
Allow Dangling Z Lines == [ ON | {OFF} ] 38
Default Land Z == 38
Interpolate ZC [ {} | ALL ] [ {} | LOWER ] 38
Interpolate [ ZHC | ZUVC ] [ {} | ALL ] [ {} | AFTER ] 39
Pause When Polyline Does Not Find Zpt == [ ON | {OFF} ] 39
Read MI Z Line [ {} | RIDGE or MAX | GULLY or MIN | HX ] [ {} | CC ] [ {} | THICK ] [ {} | ADD ] == 40
Read MI Zpts [ {} | ADD | MAX | MIN ] == 41
Read MID Zpts [ {} | ADD | MAX | MIN ] == 41
Set Zpt == 42
Write MI Zpts == 42
ZC == MIN(ZU,ZV) 42
Read File == 51
Stop 51
BC Database == <.csv_file> 9
BC Event Name == 9
BC Event Text == 10
Global Rainfall Area Factor == [ {1.0} | ] 10
Global Rainfall BC == 10
Global Rainfall Continuing Loss == [ {0} | ] 10
Global Rainfall Initial Loss == [ {0} | ] 10
Read MI BC == <.mif/.mid_file> 10
Read MI SA [ {} | Rainfall ] == <.mif/.mid_file> 11
Unused HX and SX Connections == [ {ERROR} | WARNING ] 11
Instability Water Level == [ {see_below} | ]
(Optional)
The default water level used to detect instabilities is one (1) meter higher than the highest cell elevation of all cells (whether wet, dry or permanently dry). Alternatively, this command is used to set the instability water level manually.
Water Level Checks == [ {ON} | OFF ]
(Optional)
The default “ON” option carries out checks on water levels to detect any significant instabilities. Instabilities are triggered when a water level exceeds the “Instability Water Level” (see below) or falls below the negative of the “Instability Water Level”. Switching this option off reduces the computation time very slightly.
Dostları ilə paylaş: |
