NA Tables:
No optional flags.
CS or HW Tables:
“A”: Flow area (Column 3)
“P”: Wetted perimeter (Column 4)
“F” or “N”: Vertical change in resistance (Column 5). Use “F” for a multiplication factor and “N” for a Manning’s n value.
“E”: Effective flow width (Column 6)
BG or LC Tables:
No optional flags.
|
Char(8)
|
Column_1
|
Optional. Identifies a label in the Source file that is the header for the first column of data. Values are read from the first number encountered below the label until a non-number value, blank line or end of the file is encountered.
If this field is left blank, the first column of data in the Source file is used.
|
Char(*)
|
Column_2
|
Optional. Identifies a label in the Source file that is in the header for the second column of data.
If this field is left blank, the next column of data after Column_1 is used.
|
Char(*)
|
Column_3
|
Optional. Identifies a label in the Source file that is in the header for the third column of data.
If this field is left blank, the second column of data after Column_1 is used.
|
Char(*)
|
Column_4
|
Optional. Defines the fourth column of data.
|
Char(*)
|
Column_5
|
Optional. Defines the fifth column of data.
|
Char(*)
|
Column_6
|
Optional. Defines the sixth column of data.
|
Char(*)
|
Z_Increment
|
Optional. Sets the height increment in meters to be used for calculating hydraulic properties from a XZ cross-section profile. If less than 0.01, the increment is determined automatically. Only used for XZ cross-section data.
|
Float
|
Z_Maximum
|
Optional. Sets the maximum elevation in meters to be used for calculating hydraulic properties from a XZ cross-section profile. If less than the lowest point in the cross-section profile, Z_Maximum is taken as the highest elevation in the profile. Only used for XZ cross-section data.
|
Float
|
