Refer to the exhibit. Switch#show etherchannel summary
Yüklə 2,03 Mb. Pdf görüntüsü
|
- Bu səhifədəki naviqasiya:
- Answer: A Question 50
- Answer: A Explanation + Shaping
|
Answer:
C Explanation The command “crypto key generate rsa modulus 1024” is used to generate the RSA key but this question asks about the command which is typed before entering the command to generate the RSA key so answer C is the best choice. Question 49 Refer to the exhibit. Switch A is newly configured. All VLANs are present in the VLAN database. The IP phone and PC A on Gi0/1 must be configured for the appropriate VLANs to establish connectivity between the PCs. Which command set fulfills the requirement? A. SwitchA(config-if)#switchport mode access SwitchA(config-if)#switchport access vlan 50 SwitchA(config-if)#switchport voice vlan 51 B. SwitchA(config-if)#switchport mode access SwitchA(config-if)#switchport access vlan 50 SwitchA(config-if)#switchport voice vlan untagged C. SwitchA(config-if)#switchport mode trunk SwitchA(config-if)#switchport trunk allowed vlan add 50, 51 SwitchA(config-if)#switchport voice vlan dot1p D. SwitchA(config-if)#switchport mode trunk SwitchA(config-if)#switchport trunk allowed vlan 50, 51 SwitchA(config-if)#switchport qos trust cos Answer:_A_Question_50'>Answer: A Question 50 Which QoS traffic handling technique retains excess packets in a queue and reschedules these packets for later transmission when the configured maximum bandwidth has been surpassed? A. traffic shaping B. traffic policing C. weighted random early detection D. traffic prioritization Answer: A Explanation + Shaping : retains excess packets in a queue and then schedules the excess for later transmission over increments of time. When traffic reaches the maximum configured rate, additional packets are queued instead of being dropped to proceed later. Traffic shaping is applicable only on outbound interfaces as buffering and queuing happens only on outbound interfaces. Shaping is configured in bits per second. Question 51 Refer to the exhibit. R1 learns all routes via OSPF. Which command configures a backup static route on R1 to reach the 192.168.20.0/24 network via R3? A. R1(config)#ip route 192.168.20.0 255.255.255.0 192.168.30.2 111 B. R1(config)#ip route 192.168.20.0 255.255.255.0 192.168.30.2 90 C. R1(config)#ip route 192.168.20.0 255.255.0.0 192.168.30.2 D. R1(config)#ip route 192.168.20.0 255.255.255.0 192.168.30.2 Yüklə 2,03 Mb. Dostları ilə paylaş:
|