Refer to the exhibit. Switch#show etherchannel summary

Answer:
A 
Explanation
Configuring 802.11w (GUI) 
Procedure 
Step 1
Choose WLANs > WLAN ID to open the WLANs > Edit page. 
Step 2
In the Security tab, choose the Layer 2 security tab. 
Step 3
From the Layer 2 Security drop-down list, choose WPA+WPA2. 
The 802.11w IGTK Key is derived using the 4-way handshake, which means that it can only be 
used on WLANs that are configured for WPA2 security at Layer 2. 
Note: WPA2 is mandatory and encryption type must be AES. TKIP is not valid. 
Step 4
Choose the PMF state from the drop-down list 
The following options are available: 
Disabled—Disables 802.11w MFP protection on a WLAN 
Optional—To be used if the client supports 802.11w. 
Required—Ensures that the clients that do not support 802.11w cannot associate with the 
WLAN. 
Reference: 
https://content.cisco.com/chapter.sjs?uri=/searchable/chapter/content/en/us/td/docs/w
ireless/controller/7-5/configuration-guide/b_cg75/b_cg75_chapter_01001100.html.xml
 
Note: When you create a MAC address filter on WLCs, users are granted or denied access to the 
WLAN network based on the MAC address of the client they use 

---

Fast Transition is 802.11r, not 802.11w. 
Therefore “Set PMF to Required” is the best choice. 
Question 63
Drag and drop the IPv6 address details from the left onto the corresponding types on the right. 
Answer:
Anycast:
+ used exclusively by a non-host device 
+ assigned to more than one interface 
Multicast: 
+ derived from the FF00::/8 address range 
+ provides one-to-many communications 
Unicast:
+ includes link-local and loopback addresses 
+ identifies an interface on an IPv6 device 
Explanation
An anycast address must be assigned to a router not a host and cannot be used as a source 
address.