Refer to the exhibit. Switch#show etherchannel summary

Answer:
D 
Explanation
To configure a Cisco device as an Authoritative NTP Server, use the 
ntp master
[
stratum
] 
command -> Only Option A and Option D are correct. 
ACL 10 is a standard ACL so we cannot configure protocol (UDP in this case) for the ACL. We 
can only configure source IP address -> Option D is correct. 
Question 11
Refer to the exhibit. 

---

Which route must be configured on R1 so that OSPF routing is used when OSPF is up. But the 
server is still reachable when OSPF goes down? 
A. ip route 10.1.1.10 255.255.255.255 172.16.2.2 100 
B. ip route 10.1.1.0 255.255.255.0 gi0/1 125 
C. ip route 10.1.1.0 255.255.255.0 172.16.2.2 100 
D. ip route 10.1.1.10 255.255.255.255 gi0/0 125 
Answer:_C_Question_13'>Answer:_D_Question_12'>Answer:
D 
Question 12
How does Rapid PVST+ create a fast loop-free network topology? 
A. It requires multiple links between core switches 
B. It maps multiple VLANs into the same spanning-tree instance 
C. It generates one spanning-tree instance for each VLAN 
D. It uses multiple active paths between end stations 
Answer:
C 
Question 13
Which WLC management connection type is vulnerable to man-in-the-middle attacks? 
A. SSH 
B. HTTPS 
C. Telnet 
D. console 

---

Answer:
C 
Explanation
As you know, telnet is insecure. By default, telnet is disabled on Cisco WLCs. So, if you want to 
use telnet, you must enable it. 
Question 14
Refer to the exhibit. 
Which command configures OSPF on the point-to-point link between routers R1 and R2? 
A. network 10.0.0.0 0.0.0.255 area 0 
B. neighbor 10.1.2.0 cost 180 
C. ip ospf priority 100 
D. router-id 10.0.0.15