Cnc lessons p2 cnc simulation Systems, 2015 p3 cnc simulation Systems, 2015 Table of Contents

---

CNC LESSONS

---

p2
© CNC Simulation Systems, 2015

---

p3
© CNC Simulation Systems, 2015
Table of Contents
Create New Folder and Lesson
4
Define Billet
6
Define Tooling
8
Enter CNC Lesson
10
Running a CNC Lesson
12

---

p4
© CNC Simulation Systems, 2015
Create New Folder and Lesson
Important: make sure you are in Master Mode.
 

Click on the

button and then the
button to select
mode.
CNCTRAIN includes several CNCteach lessons covering the G and M codes of the active CNC
control. They are stored in the 'G and M CODES' folder and can be selected and changed or
copied and pasted into a new lesson.
CREATE NEW FOLDER AND LESSON
You can click on the 
button to return to 
mode. For now stay in
CNCTEACH MODE.
Click on the
button to display the CNCTEACH LESSONS form.
Enter a Folder name in the top left pull down edit box. Click
on the 
button to create a new folder.

---

p5
© CNC Simulation Systems, 2015
Enter a file name in the top right pull down edit box. Click on the 
button
to create a new filename.
-o-

---

p6
© CNC Simulation Systems, 2015
Define Billet
Define Billet
Select from the Command List and add the [BILLET] X150Y100Z20: by pressing the 
button.
Select from the Command List and add the [BILLET SHIFT] X0Y0Z0: by pressing the 
button.
Select from the Command List and add the [MATERIAL]=Mild Steel: by pressing the 
button.
Edit the material as required
Select from the Command List and add the [CLEAR BILLET]: by pressing the 
button.
These commands will set the 'Billet Size'
and 'Billet Datum' shift values. If the billet datum is the bottom left hand corner then there
is no need to set this command. Clear Billet will redraw the billet after Cycle Start.
Edit the billet values as shown above.

---

p7
© CNC Simulation Systems, 2015
Use the 
button at anytime to save the lesson to your hard drive.
Press the Cycle Start button and the billet should be redrawn.
-o-

---

p8
© CNC Simulation Systems, 2015