Cisco Certified Network Associate 0 (ccna)

Correct Answer: B


QUESTION 39
Refer to the exhibit.

Which command set configures ROUTER-1 to allow Internet access for users on the 192.168.1.0/24 subnet while using 209.165.202.129 for Port Address Translation?

A. ip nat pool CCNA 192.168.0.0 192.168.1.255 netmask 255.255.255.0

access-list 10 permit 192.168.0.0 0.0.0.255
ip nat inside source list 10 pool CCNA overload
B. ip nat pool CCNA 209.165.202.129 209.165.202.129 netmask 255.255.255.255
access-list 10 permit 192.168.1.0 255.255.255.0 ip nat inside source list 10 pool CCNA overload
C. ip nat pool CCNA 192.168.0.0 192.168.1.255 netmask 255.255.255.0
access-list 10 permit 192.168.0.0 255.255.255.0 ip nat inside source list 10 pool CCNA overload
D. ip nat pool CCNA 209.165.202.129 209.165.202.129 netmask 255.255.255.255
access-list 10 permit 192.168.1.0 0.0.0.255
ip nat inside source list 10 pool CCNA overload


Correct Answer: D


QUESTION 40
Refer to the exhibit.

A multivendor network exists and the company is implementing VoIP over the network for the first time. Which configuration is needed to implement the neighbor discovery protocol on the interface and allow it to remain off for the remaining interfaces?

1. 
   SW1(config)#no cdp enable
   

SW1 (config)#interface gigabitethernet1/0/1 SW1(config-if)#cdp run

2. 
   SW1(config)#lldp enable
   

SW1(config)#interface gigabitethernet1/0/1 SW1(config-if)#lldp run

3. 
   SW1(config)#lldp run
   

SW1 (config)#interface gigabitethernet1/0/1 SW1(config-if)#lldp enable

4. 
   SW1(config)#no cdp run SW1(config)#interface gigabitethernet1/0/1 SW1(config-if)#lldp transmit
   

SW1(config-if)#lldp receive