|
add to .tcf file:
BC Database == ..\bc dbase\my bc dbase.csv
-
If using BC Event Name and BC Event Text (strongly recommended where a range of different events occurs – see Section 3.17.3) enter these commands into the .tcf file. For example:
add to .tcf file:
BC Event Text == _event_
BC Event Name == Q100
Setup up simulation times and other controls (.tcf file)
-
Determine when the simulation is to start, end, etc. The mandatory and most common commands used are: Start Time, End Time, Timestep, Map Output Data Types, Start Map Output, Map Output Interval, Output Folder, Store Maximums and Minimums and Write Check Files.
add to .tcf file:
Start Time == -10 ! start simulation at -10 hours
End Time == 30 ! end simulation at 30 hours
Timestep == 10 ! use a timestep of 10 seconds
Map Output Data Types == hVqd ! output levels, velocities, unit flows & depths
Start Map Output == 0 ! start map output at zero hours
Map Output Interval == 1800 ! output SMS data every 30 minutes
Output Folder == ..\results ! output results to the results folder
Store Maximums and Minimums == ON MAXIMUMS ONLY ! save peak values only
Write Check Files == ..\check\2d ! write check files and prefix them with “2d”
Set initial water levels
-
Set the initial water levels in the 1D and 2D domains using the various commands (see Section 3.16).
Run the model!
-
Run TUFLOW using my_model.tcf (see Section 4). No doubt it will run perfectly!
Dostları ilə paylaş: | 
