Installation Guide: IntelliFlo3 and IntelliPro3 vsf pool Pump

STRAINER POT BOLT INSERTS (x6 or x8)
STRAINER POT BOLTS (x6 or x8)
WIRING COVER
DRIVE COVER
DRIVE COVER SCREWS (x4)
DRIVE
DRIVE TO MOTOR SCREWS(x4)
MOTOR SHROUD (HALF)
DIFFUSER O-RING
DIFFUSER
IMPELLER
SEALPLATE
SEALPLATE O-RING
SHAFT SEA
L
DIFFUSER SCREW
S
MOTOR BOLTS (x4)
MOTOR
SHROUD SCREWS (x4)
DRIVE CONNECTOR GASKE
T
FOOT
FOOT SCREW
MOTOR SHROUD (HALF)
DRAIN PLUGS (x2)
DRAIN PLUG O-RINGS (x2)
STRAINER PO
T
LID O-RING
BASKET
LI
D
Pump Disassembly/Reassembly Diagram

---

18
INTELLIFLO3™ VSF / INTELLIPRO3™ VSF Variable Speed and Flow Pump Installation and Maintenance Guide
Drive Removal and Installation
TO DISASSEMBLE AND REMOVE THE DRIVE:
1. 
Press ON/STOP to stop the pump and 
disconnect all power to the pump at the circuit 
breaker.
2. Loosen the two captive Phillips-head Wiring 
Cover Screws. Remove the Wiring Cover from 
the Drive.
3. Disconnect main power wiring and remove the 
Automation Terminal Blocks from the drive.
4. Remove the four Phillips-head Drive Cover 
Screws. Remove the Drive Cover from the 
Drive.
5. Remove the four Phillips-head Drive-to-Motor 
Screws.
6. Gently separate the Drive from the Motor/
Hydraulic Assembly and place it aside.
TO INSTALL THE DRIVE:
1. Ensure the drive connection gasket is not 
damaged and is in place.
Do not reassemble with a damaged or missing 
gasket. Replace the gasket if damaged.
2. Align the Drive with the Drive Connection and seat the drive onto the motor.
3. Secure the Drive to the motor with the four Drive to Motor Screws.
4. Reinstall the Drive Cover and secure it with the four Drive Cover Screws.
5. Rewire automation and power cables that were disconnected during drive removal. Refer to 
Electrical Installation, 
page 3
and 
Connecting to an Automation System, page 4
.
6. Reinstall the Wiring Cover and secure it with the two Wiring Cover Screws.