Installation Guide: IntelliFlo3 and IntelliPro3 vsf pool Pump


IMPORTANT SAFETY INSTRUCTIONS



Yüklə 6,98 Mb.
Pdf görüntüsü
səhifə5/37
tarix16.12.2023
ölçüsü6,98 Mb.
#182724
1   2   3   4   5   6   7   8   9   ...   37
intelliflo3-pro3-vsf-install-guide

IMPORTANT SAFETY INSTRUCTIONS
HAZARDOUS PRESSURE: STAND CLEAR OF PUMP 
AND FILTER DURING START UP.
Circulation systems operate under high pressure. When 
any part of the circulating system (i.e. locking ring, pump, 
filter, valves, etc.) is serviced, air can enter the system 
and become pressurized. Pressurized air can cause the 
pump housing cover, filter lid, and valves to violently 
separate which can result in severe personal injury or death. Filter tank lid and 
strainer cover must be properly secured to prevent violent separation. Stand 
clear of all circulation system equipment when turning on or starting up pump.
Before servicing equipment, make note of the filter pressure. Be sure that 
all controls are set to ensure the system cannot inadvertently start during 
service. Turn off all power to the pump.
IMPORTANT: Place filter manual air 
relief valve in the open position and wait for all pressure in the system 
to be relieved. 
Before starting the system, fully open the manual air relief valve and place 
all system valves in the “open” position to allow water to flow freely from the 
tank and back to the tank. Stand clear of all equipment and start the pump.
IMPORTANT: Do not close filter manual air relief valve until all pressure 
has been discharged from the valve and a steady stream of water 
appears. 
Observe filter pressure gauge and be sure it is not higher than the 
pre-service condition. 
General Installation Information 
• 
All work must be performed by a qualified service professional, and must 
conform to all national, state, and local codes. 
• 
Install to provide drainage of compartment for electrical components. 
• 
These instructions contain information for a variety of pump models and 
therefore some instructions may not apply to a specific model. All models 
are intended for use in swimming pool applications. The pump will function 
correctly only if it is properly sized to the specific application and properly 
installed.
Pumps improperly sized or installed or used in 
applications other than for which the pump was 
intended can result in severe personal injury or death. These risks may 
include but not be limited to electric shock, fire, flooding, suction entrapment 
or severe injury or property damage caused by a structural failure of the 
pump or other system component.

Yüklə 6,98 Mb.

Dostları ilə paylaş:
1   2   3   4   5   6   7   8   9   ...   37




Verilənlər bazası müəlliflik hüququ ilə müdafiə olunur ©azkurs.org 2024
rəhbərliyinə müraciət

gir | qeydiyyatdan keç
    Ana səhifə


yükləyin