Cisco Certified Network Associate 0 (ccna)

Correct Answer: C


QUESTION 41
Refer to the exhibit.

An engineer is configuring an EtherChannel using LACP between Switches 1 and 2. Which configuration must be applied so that only Switch 1 sends LACP initiation packets?

1. 
   Switch1(config-if)#channel-group 1 mode on Switch2(config-if)#channel-group 1 mode passive
   
2. 
   Switch1(config-if)#channel-group 1 mode passive Switch2(config-if)#channel-group 1 mode active
   
3. 
   Switch1(config-if)#channel-group 1 mode active Switch2(config-if)#channel-group 1 mode passive
   
4. 
   Switch1(config-if)#channel-group 1 mode on Switch2(config-if)#channel-group 1 mode active
   

Correct Answer: C


QUESTION 42
Refer to the exhibit.

SW1 = 24596 0018.184e.3c00 SW2 = 28692 004a.14e5.4077 SW3 = 32788 0022.55cf.dd00 SW4 = 64000 0041.454d.407f

Which switch becomes the root of a spanning tree for VLAN 20 if all links are of equal speed?

1. 
   SW1
   
2. 
   SW2
   
3. 
   SW3
   
4. 
   SW4
   

Correct Answer: A


QUESTION 43
Refer to the exhibit.


Router1(config)#interface GigabitEthernet0/0
Router1(config-if)#ip address 209.165.200.225 255.255.255.224 Router1(config-if)#ip nat outside
Router1(config)#interface GigabitEthernet0/1 Router1(config-if)#ip nat inside Router1(config)#interface GigabitEthernet Router1(config-if)#encapsulation dot1Q 100
Router1(config-if)#ip address 10.10.10.1 255.255.255.0 Router1(config)#interface GigabitEthernet0/1.200 Router1(config-if)#encapsulation dot1Q 200
Router1(config-if)#ip address 10.10.20.1 255.255.255.0 Router1(config)#ip access-list standard NAT_INSIDE_RANGES Router1(config-std-nacl)#permit 10.10.10.0 0.0.0.255
Router1(config)#ip nat inside source list NAT_INSIDE_RANGES interface GigabitEthernet0/0 overload

Users on existing VLAN 100 can reach sites on the Internet. Which action must the administrator take to establish connectivity to the Internet for users in VLAN 200?

1. 
   Define a NAT pool on the router.
   
2. 
   Update the NAT INSIDF RANGFS ACL
   
3. 
   Configure the ip nat outside command on another interface for VLAN 200
   
4. 
   Configure static NAT translations for VLAN 200