Cisco Certified Network Associate 0 (ccna)

Correct Answer: B


QUESTION 53
Refer to the exhibit.

The primary route across Gi0/0 is configured on both routers. A secondary route must be configured to establish connectivity between the workstation networks. Which command set must be configured to complete this task?

1. 
   R1
   

ip route 172.16.2.0 255.255.255.240 172.16.0.2 113 R2
ip route 172.16.1.0 255.255.255.0 172.16.0.1 114

2. 
   R1
   

ip route 172.16.2.0 255.255.255.240 172.16.0.5 89 R2
ip route 172.16.1.0 255.255.255.0 172.16.0.6 89

3. 
   R1
   

ip route 172.16.2.0 255.255.255.248 172.16.0.5 110 R2
ip route 172.16.1.0 255.255.255.0 172.16.0.6 110

4. 
   R1
   

ip route 172.16.2.0 255.255.255.224 172.16.0.6 111 R2
ip route 172.16.1.0 255.255.255.0 172.16.0.5 112


Correct Answer: D


QUESTION 54
Refer to the exhibit.

Which action must be taken so that neighboring devices rapidly discover switch Cat9300?

1. 
   Enable portfast on the ports that connect to neighboring devices
   
2. 
   Configure the cdp holdtime 10 command on switch Cat9300
   
3. 
   Configure the cdp timer 10 command on the neighbors of switch Cat9300
   
4. 
   Configure the cdp timer 10 command on switch Cat9300
   

Correct Answer: D


QUESTION 55
Refer to the exhibit.

SW2 is replaced due to a hardware failure. A network engineer starts to configure SW2 by copying the Fa0/1 interface configuration from SW1. Which command must be configured on the Fa0/1 interface of SW2 to enable PC1 to connect to PC2?

1. 
   switchport mode trunk
   
2. 
   switchport trunk native vlan 10
   
3. 
   switchport trunk allowed remove 10
   
4. 
   switchport mode access