Cisco Certified Network Associate 0 (ccna)

Correct Answer: A
LACP Configuration Sim


QUESTION 1
Guidelines

This is a lab item in which tasks will be performed on virtual devices.

+ Refer to the Tasks tab to view the tasks for this lab item.
+ Refer to the Topology tab to access the device console(s) and perform the tasks.
+ Console access is available for all required devices by clicking the device icon or using the tab(s) above the console window.
+ All necessary preconfigurations have been applied.
+ Do not change the enable password or hostname for any device.
+ Save your configurations to NVRAM before moving to the next item.
+ Click Next at the bottom of the screen to submit this lab and move to the next question.
+ When Next is clicked, the lab closes and cannot be reopened.


Topology


^A. Tasks

Physical connectivity is implemented between the two Layer 2 switches, and the network connectivity between them must be configured.

1. 
   Configure an LACP EtherChannel and number it as 44; configure it between switches SW1 and SW2 using interfaces Ethernet0/0 and Ethernet0/1 on both sides. The LACP mode must match on both ends.
   
2. 
   Configure the EtherChannel as a trunk link.
   
3. 
   Configure the trunk link with 802.1q tags.
   
4. 
   Configure VLAN ‘MONITORING’ as the untagged VLAN of the EtherChannel.
   

Solution


Task 1 + 2 + 3.

SW1, SW2:

interface range E0/0 – 1 channel-group 44 mode active no shutdown

interface Port-channel 44

switchport trunk encapsulation dot1q switchport mode trunk


Task 4.

It seems VLAN 746 is the “MONITORING” VLAN. Please check with the “show vlan” command on both switches to be sure. If so we will set this VLAN the native VLAN on both switches.

SW1, SW2:

interface Port-channel 44 switchport native vlan 746

Don’t forget to save the configuration on both switches: SW1, SW2#copy running-config startup-config