Cisco Certified Network Associate 0 (ccna)

Correct Answer: A


QUESTION 17
Refer to the exhibit.

--Some output missing-- Routing Descriptor Blocks:

• 
  directly connected, via Ethernet0/1
  

Route metric is 0, traffic share count is 1

CPE# ping 203.0.113.1

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 203.0.113.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/oax = 1/1/1 ms

CPE# show ip route

Gateway of last resort is 198.51.100.1 to network 0.0.0.0 B* 0.0.0.0/0 [20/0] via 198.51.100.1, 00:02:07
198.51.100.0/24 is variably subnetted, 2 subnets, 2 masks
C 198.51.100.0/30 is directly connected, Ethernet0/0 L 198.51.100.2/32 is directly connected, Ethernet0/0
203.0.113.0/24 is variably subnetted, 2 subnets, 2 masks C 203.0.113.0/30 is directly connected, Ethernet0/1
L 203.0.113.2/32 is directly connected, Etheraet0/1

After configuring a new static route on the CPE, the engineer entered this series of commands to verify that the new configuration is operating normally. When is the static default route installed into the routing table?

1. 
   when the default route learned over external BGP becomes invalid
   
2. 
   when 203.0.113.1 is no longer reachable as a next hop
   
3. 
   when the default route learned over external BGP changes its next hop
   
4. 
   when a route to 203.0.113.1 is learned via BGP
   

Correct Answer: A


QUESTION 18
Refer to the exhibit.

Wireless LAN access must be set up to force all clients from the NA WLAN to authenticate against the local database. The WLAN is configured for local EAP authentication. The time that users access the network must not be limited. Which action completes this configuration?

1. 
   Check the Guest User Role check box
   
2. 
   Clear the Lifetime (seconds) value
   
3. 
   Set the Lifetime (seconds) value to 0
   
4. 
   Uncheck the Guest User check box