Cisco Certified Network Associate 0 (ccna)

Correct Answer: B


QUESTION 4
What is the PUT method within HTTP?

1. 
   It replaces data at the destination.
   
2. 
   It displays a web site.
   
3. 
   It is a read-only operation.
   
4. 
   It is a nonidempotent operation.
   

Correct Answer: A


QUESTION 5
Refer to the exhibit.

R1
interface GigabitEthernet0/1

ip address 192.168.12.1 255.255.255.128
no shutdown router ospf 1
network 192.168.12.1 0.0.0.0 area 1

R2
interface GigabitEthernet0/1

ip address 192.168.12.2 255.255.255.128
no shutdown

A network engineer started to configure two directly-connected routers as shown. Which command sequence must the engineer configure on R2 so that the two routers become OSPF neighbors?

1. 
   interface GigabitEthernet0/1 ip ospf 1 area 0
   
2. 
   interface GigabitEthernet0/1 ip ospf 1 area 1
   
3. 
   router ospf 1
   

network 192.168.12.0 0.0.0.127 area 0

4. 
   router ospf 1
   

network 192.168.12.1 0.0.0.0 area 1


Correct Answer: B


QUESTION 6
Refer to the exhibit.

R1# show ip route

Codes: C - connected, S - static, I - IGRP, R - rip, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, * - candidate default
U - per-user static route, o - ODR Gateway of last resort is not set
C 10.0.0.0/8 is directly connected, Loopback0 10.0.0.0/8 is variably subnetted, 4 subnets, 2 masks
O 10.0.1.3/32 [110/100] via 10.0.1.100, 00:39:08, Serial0
C 10.0.1.0/24 is directly connected, Serial0
O 10.0.1.5/32 [110/5] via 10.0.1.50, 00:39:08, Gigabit Ethernet 0/0 D 10.0.1.4/32 [110/10] via 10.0.1.4, 00:39:08, Gigabit Ethernet 0/0

What does route 10.0.1.3/32 represent in the routing table?

1. 
   all hosts in the 10.0.1.0 subnet
   
2. 
   the source 10.0.1.100
   
3. 
   a single destination address
   
4. 
   the 10.0.0.0 network