OPERATION Drive Controls/Buttons Refer to Drive LED Indicators , page 19 for a list of drive LED behaviors. CONNECT: Press to connect the pump to the Pentair
Home app. Refer to the
Pentair Home User's Guide (P/N 356088) for instructions.
ON/STOP: Press to enable or disable the pump. By
default, pressing this button will either begin the priming
cycle and then run the appropriate program or deactivate
the pump.
If the pump is deactivated via the ON/STOP button, ON/
STOP must be pressed again before the pump will operate.
QUICK CLEAN: Press to manually start the Quick Clean
program. This feature can used to temporarily override
a schedule and increase pump speed while vacuuming
or adding chemicals to the pool.
Once a Quick Clean cycle has ended, the pump will
resume its normal schedule.
Priming the Pump Do NOT run the pump dry. If the pump is run dry,
the shaft seal will be damaged and the pump will
start leaking. If this occurs, the damaged seal must be replaced.
ALWAYS maintain proper water level in your
pool (half way up skimmer opening). If the
water level falls below the skimmer opening, the pump will draw air
through the skimmer, losing the prime and causing the pump to run
dry, resulting in a damaged seal. Continued operation in this manner
could cause a loss of pressure, resulting in damage to the pump
case, impeller and seal and may cause property and personal injury.
This pump is shipped with Priming ENABLED. Unless
the priming settings are changed, the pump will speed
up to the maximum speed when the pump is powered on
for the first time, and the ON/STOP button is pressed.
The pump must be filled with water and primed before
initial startup and after servicing. To avoid permanent
damage to the pump, follow the instructions below.
Refer to the
Pentair Home User's Guide (P/N 356088) for a list of Pentair Home priming settings and
programming instructions.
Note: If programming priming via the optional Drive-
mounted Touchscreen Controller, refer to
Priming Parameters, page 11 .
Strainer
Pot Lid
Suction Port
