3HP PUMP UNION KIT (P/N 410028) 2.5” Plumbing 2” Plumbing Included Reducer Bushing 1.5HP PUMP UNION KIT (P/N 351157) 1.5” Plumbing 2” Plumbing 2” PVC Coupling (not included) 3” Plumbing 3HP PUMP UNION KIT (P/N 410029) *sold separately UNION KIT OPTIONS INSTALLATION Only a qualified plumbing professional should install
the pump. Refer to
“Important Safety Instructions” on pages i - ii for additional installation and safety
information.
Note: The pump should not be connected in series
with other pumps.
Location Be sure the pump location meets the following requirements: 1. Install the pump a minimum of 5 feet (1.5 m)
from the inside wall of the pool. Canadian
installations require a minimum of 9.8 feet (3 m)
from the inside wall of the pool.
2. Install the pump a minimum of 3 feet (0.9 m)
from a heater outlet.
3. Do not install the pump more than 10 feet (3.1
m) above the pool water level.
4. Provide at least 3-inch (7.6 cm) of side and rear
clearance for motor disassembly and removal.
5. Provide at least 6-inch (15.2 cm) of top
clearance for drive disassembly and removal.
6. Install the pump in a well ventilated location
protected from excessive moisture, dirt and heat
(i.e., rain gutter downspouts, sprinklers, etc.)
7. Secure the pump to the equipment pad at the
two anchor points located under the pump volute.
Anchor points are sized for up to 3/8-inch concrete
anchors.
8. Do NOT install this pump within an outer enclosure
or beneath the skirt of a hot tub or spa unless
marked accordingly.
